Skip to content
Marking on Flywheel for Surface as well as Circumference Marking

Marking on Flywheel for Surface as well as Circumference Marking

Requirement of Identification and Marking on Flywheel

 

  • Traceability on Surface and circumference of each Flywheel .
  • There are different types of Flywheels (shape and dimension-wise).
  • Job Identification required for marking of appropriate Data.

 

Functional Specification

 

  • Gear Mechanism for rotating of job.
  • Flywheel Clamped By Pneumatic Cylinder.

 

Constraints

 

  • The very fast production speed requires a robust and efficient marking.
  • Need for permanent marking.
  • Need System to Minimize Human error.
  • Either Circumference Marking Or Surface Marking.

 

Machine Proposed : MNSTC Integrated

 

Process Flow

 

  • Using a hand lever to clamp the flywheel job through pneumatic cylinder.
  • After clamping data will released from controller and marking will done.
  • After either circumference or surface marking signal goes for decamp of job.
  • After decamping job can be unloaded.
  • Loading and Unloading job is manual  .

 

 

    Related Posts

    Horizontal Surface Marking on Crankshaft
    December 06, 2022
    Horizontal Surface Marking on Crankshaft

    Requirement of identification and Marking on Crankshaft   Traceability on Face of each Crankshaft . There are 4 Type...

    Read More
    Marking on multiple bombshells.
    December 06, 2022
    Marking on multiple bombshells.

    Requirement of Identification and Marking on Shaft   Traceability on Surface of each...

    Read More
    Drawer Title
    Coupon
    Similar Products