Requirement of Identification and Marking on Shaft
- Traceability on Surface of each bombshell.
- There are same type bombshell.
- JOB Identification required for marking appropriate Data.
- Two Tray are Use and at One Tray Total 12 bombshell are Rest.
- At First Tray Machine Mark 12 bombshell at One Time, Same Time Other Tray are Doing Loading and Unloading Function.
- Screw Type Linear Actuating Mechanism Used to Actuating The Marking Machine Form One Tray Location to Other Tray Location.
- The very fast production speed requires a robust and efficient marking.
- Need for permanent marking .
- Need System to Minimize Human error.
- Large marking window required for marking a job.
- At a single loading, marking a 12 different bombshell.
- Minimized the job loading and Unloading time.
Machine Proposed : MNSPC Integrated
- PLC Interface.
- Load the job manually in tray.
- Job clamping by pneumatic clamp.
- At a same time two tray, job is loaded
- Pressed the start button the Data will released from controller and marking will done.
- After the one job loaded tray marking completed, travel the marking machine linearly by using screw type linear actuating mechanism and mark will done the another job loaded tray.
- After declamped the job loaded tray can be unloaded
- Loading and Unloading job is manual.